Determining Length of Lamp Pipe You Need for Your Lamp Project
- Measure the height of your Lamp Body plus the thickness of your Lamp Base.
- Add to these measurements at least 1/4" to accommodate the rubber washer, steel washer and locknut to be placed on the bottom of the Lamp Pipe.
- Generally, the bottom of the Lamp Pipe is the end with 3/4"L threading.
- Allow at least another 1/2" of Lamp Pipe to extend up from the top of your Lamp Body to accommodate a locknut, check ring or vase cap, shade harp bottom & socket bottom to the top of the pipe.
- If you want to add a Lamp Neck or deep Vase Cap, allow even more Lamp Pipe to extend from the top of your Lamp Body.
Check out our selections of Electrical, Lighting & Lamp Making supplies: |
Lamp Pipes & Threaded Nipples |
Cord Sets |
Light Bulbs |
Sockets |
Lamp Finials, Loops, Spindles, Necks & Spacers |
Lamp Harps & Shade Holders |
On/Off Switches & End Plugs |
Lamp Making Hardware |
Check Rings |
Socket Covers, Sleeves & Chains |
Wood Lamp Base |
Lamp Accessories |
Adapters for Lamp Pipes |
National Artcraft Co.
Phone: (330) 562-3500
Toll-Free Phone: (888) 937-2723
E-Mail: sales@nationalartcraft.com
300 Campus Drive, Aurora, Ohio 44202 USA (Map)
Hours: M-F 8:30am - 5:00pm, ET (closings)
Phone: (330) 562-3500
Toll-Free Phone: (888) 937-2723
E-Mail: sales@nationalartcraft.com
300 Campus Drive, Aurora, Ohio 44202 USA (Map)
Hours: M-F 8:30am - 5:00pm, ET (closings)
SEE OUR GOOGLE REVIEWS:
Connect with us:
All contents © • National Artcraft Company. The products depicted on this website are subject to Proposition 65 labelling in California. For more information go to www.p65warnings.ca.gov.